Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Introduction

Jitterbit Harmony supports single sign-on (SSO) with Autodesk using OAuth 2.0. This page shows how to set up and test Jitterbit Harmony SSO with Autodesk by following these steps:

  1. Configuring SSO in the Autodesk Forge Portal
    Set up Jitterbit Harmony as an app and obtain the Client IDs and Client Secrets that you will need to use as input for configuring SSO in Jitterbit Harmony.
  2. Configuring SSO in Jitterbit Harmony
    Configure and test Autodesk as the SSO provider in the Jitterbit Harmony Portal. You will need to use the Client IDs and Client Secrets obtained in the previous step.

After SSO is configured in both Autodesk and Jitterbit Harmony, members of your Jitterbit Harmony organization will be able to use their Autodesk credentials to log in to Jitterbit Harmony.

For additional information, see Autodesk documentation on API Basics and the tutorial Create an App.

Anchor
autodesk
autodesk
Configuring SSO in the Autodesk Forge Portal

Follow these steps to set up Jitterbit Harmony as an app in the Autodesk Forge portal and obtain the Autodesk OAuth Client ID and Client Secret needed for configuring SSO in Jitterbit Harmony:

  1. Log in to the Autodesk Forge portal.

    Note
    CAUTION: In order to set up SSO in Jitterbit, your Autodesk username must match your Harmony email address. This applies to the members of your Harmony organization as well, unless they are configured to bypass SSO and instead use their Harmony credentials (see Configuring SSO in the Management Console).
  2. In the Autodesk Forge portal, go to My Apps and click the Create App button. You need to create an app for each of these Harmony clients:
    • WMC: This Harmony client is for the Harmony Portal (which includes Cloud Studio, API Manager, Citizen Integrator, and Management Console).

      Info
      NOTE: Although the user interface refers to WMC (the former name for the Management Console), the WMC Harmony client configuration applies to all of the web-based products accessible via the Harmony Portal, including Cloud Studio, API Manager, Citizen Integrator, and Management Console.
    • Studio: This Harmony client is for Design Studio. An app for this client must be created, even if you do not intend to use Design Studio.
    For each app:
  3. On clicking Create App, the OAuth Client ID and Client Secret are provided. Retain these for later use, as they will be required when configuring SSO in Jitterbit Harmony.

Anchor
configure-sso
configure-sso
Configuring SSO in Jitterbit Harmony

Follow the instructions for Configuring SSO in the Management Console. When entering information into the Edit Organization SSO Provider Info screen, use the values obtained above for each Harmony client:

  • Client Id: Paste the Autodesk OAuth Client ID.
  • Client Secret: Paste the Autodesk Client Secret.

Image Added

Click Test Configuration for each Harmony client and then click Save. Both clients need to be successfully tested before the Save button becomes enabled.

Panel
borderColor#65379B
titleColor#FFFFFF
titleBGColor#65379B
titleOn This Page
Table of Content Zone

Table of Contents
maxLevel3
minLevel2

Panel
borderColor#FF7C4C
titleColor#FFFFFF
titleBGColor#FF7C4C
titleRelated Articles
Panel
borderColor#00B886
titleColor#FFFFFF
titleBGColor#00B886
titleRelated Topics

HideElements
metastrue

Last updated: 

Lastmodifieddate